Side terae - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Side terae - Nissan 240SX 1991-1992 Workshop Manual
Side terae
REAR AXLE — Drive Shaft
Side flange
Drive shaft
(OC) 34-44 (3.5 - 4.5, 25 - 33)
(C) 206 - 275 (21 - 28, 152 - 203) Insulator 1} : Nem (kg-m, ft-lb) Adjusting cap SRA380A Removal
Side terae
N\A When removing drive shaft, cover boots with waste cloth to prevent damage to them.
FINAL DRIVE SIDE
Remove side flange mounting bolt and separate shaft.
WHEEL SIDE
Remove drive shaft by lightly tapping it with a copper hammer. To avoid damaging threads of drive shaft, install a nut while removing drive shaft.
SRA116A Installation @ Insert drive shaft from wheel hub and temporarily tighten wheel bearing lock nut. @ Tighten side flange mounting bolts to specified torque. @ Tighten wheel bearing lock nut to specified torque.
RA-13
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.