Gear Components - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Gear Components - Nissan 240SX 1991-1992 Workshop Manual
Gear Components
DISASSEMBLY Shift Control Components (Cont'd)
7. Remove E-ring from O.D. and reverse fork rod.
8. Draw out O.D. and reverse fork shaft by rotating O.D. and reverse bracket counterclockwise.
Gear Components
1. Before removing gears and shafts, measure each gear end play. Gear end play: Refer to S.D.S.
If not within specification, disassemble and check contact
Mainshaft or
surface of gear to hub, washer, bushing, needle bearing and
bushing shaft.
SMT025
2. Mesh 2nd and reverse gear, then draw out counter front bearing with suitable puller.
3. Remove snap ring and then remove sub-gear bracket, sub-gear spring and sub-gear.
Draw out counter drive gear with main drive gear assembly
4. with suitable puller.
@ When drawing out main drive gear assembly, be careful
not to drop pilot bearing and baulk ring.
SMT162A
MT-13
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.