AUTOMATIC SEAT BELT SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › AUTOMATIC SEAT BELT SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
AUTOMATIC SEAT BELT SYSTEM
AUTOMATIC SEAT BELT SYSTEM
Replacement of Rear Switch Assembly (Cont'd) ASSEMBLY
Shoulder belt buckle switch
R switch
(Bottom color is black.)
1. Set rear switch assembly to switch holder A.
Rear limit switch - . . assembly | (Bottom color is green.) Be sure to set rear limit switch and shoulder belt buckle switch to appropriate position.
2. Cover switch holder A by switch holder B. Switch holder B Take care not to catch harness between holders A and B.
3. Slide switch holder cover up until it is aligned with switch holders A and B.
4. Slide locking device down until it is aligned with switch holders.
SBF660E
5. Secure screws to locking device assembly. ©) :
0.6-0.9 N.m (0.06 - 0.09 kg-m, 0.4 - 0.7 ft-Ib)
SBF661E
6. Apply adhesive on adhesive surface of inner seal rubber.
Do not apply too much adhesive.
Uy : Adhesive portion
7. Fix inner seal rubber to locking device assembly.
Inner seal rubber SBF662E
BF-31
Parts & tools for this job For Nissan 240SX
- TOOLOBD2 scanner with SRSSearch: OBD2 scanner ABS SRS
- TOOLTrim removal tool kitSearch: trim removal tool kit
As an Amazon Associate we earn from qualifying purchases.