TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
‹ Prev TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop ManualNext › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES

TROUBLE DIAGNOSES
Consult (Cont’d)
DATA MONITOR MODE
| MONITOR ITEM CONDITION | SPECIFICATION | CHECK ITEM WHEN OUTSIDE SPEC. |
|---|---|---|
| MONITOR ITEM CONDITION Tachometer: Connect | SPECIFICATION Almost the same speed as | OUTSIDE SPEC. Harness and connector |
| CAS, RPM (POS) Tachometer: Connect e Run engine and compare the CONSULT value. tachometer indication with | Almost the same speed as the CONSULT value. | Harness and connector Crank angle sensor |
| e Engine: After warming up, idle the engine Idle | 1.0 - 1.5V | Harness and connector |
| AIR FLOW MTR up, idle the engine e A/C switch ‘‘OFF”’ Idle 2,000 rpm | 1.0 - 1.5V 1.4- 1.9V | Harness and connector Air flow meter |
| e@ Shift lever ‘‘N” 2,000 rpm | 1.4- 1.9V | Harness and connector |
| ENG TEMP SEN e Engine: After warming up | More than 70°C (158°F) | Engine temperature sen- |
| sor | ||
| EXH GAS SEN e Engine: After warming up Maintaining engine speed | 0 <> Approx. 1.5V LEAN <> RICH | e@ Harness and connector e Exhaust gas sensor |
| e Engine: After warming up Maintaining engine speed M/R F/C MNT at 2,000 rpm | LEAN <> RICH Changes more than 5 times | e Exhaust gas sensor |@ Intake air leaks |
| M/R F/C MNT at 2,000 rpm | Changes more than 5 times during 10 seconds. | |@ Intake air leaks @ Injectors |
| CAR SPEED SEN e@ Turn drive wheels and compare speedometer indica- | Almost the same speed as__ | @ Harness and connector | |
| tion with the CONSULT value | the CONSULT value | e Vehicle speed sensor |
| e Battery | ||
| BATTERY VOLT e@ Ignition switch: ON (Engine stopped) | 11 - 14V | e@ E.C.U. power supply cir- |
| cuit | ||
| taniti itch: ON Throttle valve fully closed THROTTLE SEN e Igni ton switch: | 0.54 0.2V | ° ani and connector e rottle sensor |
| (Engine stopped) Throttle valve fully opened | Approx. 4.0V | e Throttle sensor adjust- |
| (Engine stopped) Throttle valve fully opened | Approx. 4.0V | e Throttle sensor adjust- ment |
| Harness and connector | ||
| EGR TEMP SEN* e Engine: After warming up | Less than 4.5V | Exhaust gas temperature |
| sensor | ||
| START SIGNAL __ |e Ignition switch: ON > START | OFF + ON | e Harness and connector e Starter switch |
| Throttle valve: iti itch: Idle position | ON | e Harness and connector |
| Throttle valve: iti itch: Idle position IDLE POSITION e Ignition switch: ON | ON | e Harness and connector e Throttle sensor |
| (Engine stopped) Throttle valve: Slightly open | OFF | e@ Throttle sensor adjust- ment |
| Slightly open | OFF | ment |
| AIR COND SIG e Engine: After warming A/C switch “OFF” up, idle the engine A/C switch “‘ON” | OFF ON | e Harness and connector e Air conditioner switch |
| up, idle the engine A/C switch “‘ON” | ON | e Air conditioner switch |
| Shift lever ‘‘P’’ or ‘‘N” NEUTRAL SW @ Ignition switch: ON Except above | ON OFF | e Harness and connector e Neutral switch |
Remarks: The monitor item marked ‘*” is applicable to vehicles for California only. Specifications are reference values.
EF & EC-49
‹ Prev TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop ManualNext › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.