Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 16 — Engine Stalls when

the Electrical Load is Heavy

1 N.G.

CHECK BATTERY AND ALTERNATOR.

Repair or replace. Vv Check battery and alternator condition. (Refer to EL section.) O.K. v No Go to fq.

PERFORM POWER BALANCE TEST.

Vv

1. Perform ‘“‘POWER BALANCE” SEF389! in “ACTIVE TEST” mode. im

2. Is there any cylinder which

mactive test gL]

does not produce a momen-

* & * POWER BALANCE * *® *

tary engine speed drop? =s==== MONITOR ===== OR

CAS-RPM (REF)

—_712rpm

®) harness connector one at a

When disconnecting each injec-

AIR FLOW MTR

__‘1.02V

AAC VALVE

37% time, is there any cylinder which

M2 Le test

does not produce a momentary LL IL Les engine speed drop? Yes SEF729K y maa No

CHECK INJECTOR.

Check injector(s) and cir- DISCONNECT €>.

1. Remove distributor assembly from cuit(s). engine. (Crank angle sensor harness connector should remain connected.)

2. Disconnect ignition coil harness con- nector.

3. Turn ignition switch ON. (Do not start engine.) Fuel injector connector

4. When rotating crank angle sensor aA =", shaft, does each injector make an SEF738K operating sound? Yes 4 v N.G.

CHECK IGNITION SPARK.

Check ignition coil, power

1. Disconnect ignition wire from rocker transistor unit and cir- cuits. (See page EF & cover.

2. Connect a known good spark plug to

EC-114.) the ignition wire.

3. Place end of spark plug against a suitable ground and crank engine.

4. Check for spark. SEF837K O.K. v (Go to ® on next page.) Ignition wire

4 a Spark plug f i » SEF282G

EF & EC-87

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.