TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Ti Diagnostic Procedure 6 SYMPTOM: Vehicle does not creep backward when selecting ‘‘R’’ range. 1 | Check A/T fluid level again. > Refill A.T.F. O.K. N.G, in both “1” and “’R’’ range ¥ C + | SAT638A -
1. Remove.control valve assem- bly. — Refer to “ON-VEHI- Check stall revolution with selector lever in “’1” and “R”
CLE SERVICE”
range.
2. Check the following items. O.K. OK L vq > Valves to control line pressure hin 1 fange (Pressure regulator valve, pilot N.G. in ‘“R’’ range. valve and pilot filter) | ; ; @ Line pressure solenoid 11) 3° Disassemble A/T. Check line pressure at idle with |N.G.
4. Check the following items.
selector lever in “R” range.
© Oil pump assembly — Refer to “PRESSURE TESTING”. @ Torque converter Reverse clutch assembly @ 4 | ,
© High clutch assembly
N.G. |
1. Remove oil pan.
@ Low & reverse brake assembly
|
2. Check fluid condition. Low one-way clutch @ O.K. Vv ; N.G. .
1. Perform A/T control unit »| Check again. input/output signal inspection.
2. If N.G., recheck A/T control
{ok unit pin terminals for damage
INSPECTION END
or connection of A/T control unit harness connector.
SAT171B
AT-64
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.