Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 29 (Cont'd)

Non-California model

INSPECTION START

Is lifted up and down. ol y

INSPECTION END

CHECK OVERALL FUNCTION.

y 1) Start engine and warm it up suffi- ciently. 2) Make sure that E.G.R. control valve spring is lifted up and down when racing engine (2,000 rpm). (Use your finger.) Is not lifted up and down. ¥

O.K._»| CHECK COMPONENTS

CHECK VACUUM SOURCE TO E.G.R.

CONTROL VALVE.

(E.G.R. control valve and 1) Disconnect vacuum hose to E.G.R. B.P.T. valve). Vacuum hose connected control valve. Refer to ‘Electrical Com- to E.G.R. control valve 2) Make sure that vacuum exists under ponents Inspection’. MEF694A the following conditions. (See page EF & EC-165.) ee At idle: eg CONNECT N.G. Vacuum should not exist. v Engine speed is about 2,000 rpm: 105 | Replace malfunctioning Vacuum should exist. componeni(s). N.G. ®@ o Y O.K.

CHECK CONTROL FUNCTION.

CHECK VACUUM HOSE.

1) Check voltage between E.C.U. termi-

1) Check vacuum hose

nal@0Dand ground under the follow-

for clogging, cracks MEF695A and proper connection. ing conditions. Voltage: At idle Approximately 0V Engine speed is about 2,000 rpm. Battery voltage N.G. v N.G. Check the following.

CHECK POWER SUPPLY.

= —.

aA Improper connection

e Harness connectors(f9), 1) Stop engine. 2) Disconnect E.G.R. & canister control SEF816F solenoid valve harness connector. e 10A fuse e Harness continuity 3) Turn ignition switch ‘‘ON’’. DISCONNECT ——} 4) Check voltage between terminal @ between E.G.R. & can- TS ister control solenoid and ground. valve and fuse Voltage: Battery voltage If N.G., repair harness or (Gi) LV] O.K. ~ connectors. \ + ® 7,

MEF696A

EF & EC-114

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.