Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

CAUTION: e@ When installing sliding parts such as bearings and pistons, be sure to apply engine oil on the sliding surfaces. e Place removed parts such as bearings and bearing caps in their proper order and direction. e@

When tightening connecting rod bolts and main bearing cap

bolts, apply engine oil to thread portion of bolts and seating surface of nuts.

Engine front Disassembly vad

PISTON AND CRANKSHAFT

1. Place engine on a work stand.

2. Remove timing chain. Refer to ‘‘Removal”’ in “TIMING CHAIN”.

3. Remove pistons with connecting rods. @e When disassembling piston and connecting rod, remove snap rings, then heat piston to 60 to 70°C (140 to 158°F) or use piston pin press stand at room temperature.

CAUTION: @ When piston rings are not replaced, make sure that piston rings are mounted in their original positions. @ When piston rings are being replaced and no punchmark is present, piston rings can be mounted with either side up.

SEM877B

EM156 G me ©® ©

4. Remove main bearing beam and crankshaft. 7 i e Before removing main bearing beam, measure crankshaft end play. e Bolts should be loosened in two or three steps. @) ©) @) | © ©) J 7k | ® @®@ ©

@ Loosen in numerical order.

SEM248C EM-38

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.