Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Basic Inspection (Cont'd)

|

BW IGN TIMING ADJ g CL]

N.G. > Adjust engine speed by

CHECK IDLE ADJ. SCREW INITIAL SET

-- CONDITION SETTING --

turning idle adjusting RPM.

IGN/T FEEDBACK: HOLD

oN

1. Select “IGN TIMING ADJ” in screw. “WORK SUPPORT” mode. MONITOR

CAS-RPM (REF)

2. When touching “‘START”,

IGN TIMING

does engine speed fall to

IDLE POSITION

650+ 50 rpm (A/T in “‘N’’ posi- tion)? SEF727K OR

(Sa) Does engine run at 650+50 rpm

JSy/ (A/T in “‘N” position)?

O.K. 4 2 itia, 4, ~) oF v 2 N.G.

> 1. Adjust output voltage SITION. by rotating throttle sen- /qa~

CHECK THROTTLE SENSOR IDLE PO-

1. Perform ‘THROTTLE SEN. sor body. ADJ.” in “WORK SUPPORT”

2. Disconnect throttle sensor harness con- mode. nector for a few sec-

2. Check that output voltage of SEF 146 throttle sensor is approx. 0.4 onds and then recon- to 0.5V. (Throttle valve fully nect it.

@ THROTTLE SEN ADJ BL]

3. Confirm that “IDLE closes.) and “IDLE POSITION” stays “‘ON”’. POSITION” stays

# * & & ADJ MONITOR * * ¥ *

OR (oy Measure output voltage of throt-

THROTILE SEN

—0.44V

e=¢ tle sensor using voltmeter, and

====== MONITOR =======

check that it is approx. 0.4 to

CAS+RPM (REF)

0.5V. (Throttle valve fully closed.) O.K. SEF725K (Go to on next page.)

IDLE POSITION

SEF 148

EF & EC-56

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.