Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXSUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual

SUPER HICAS SYSTEM — Trouble Diagnoses

SUPER HICAS SYSTEM — Trouble Diagnoses

Diagnostic Procedure 5

SYMPTOM: System is not set in self-diagnosis mode.

START A Y O.K.

CHECK CONNECTOR CONTINU-

Poor connector connection Vv ITY. Disconnect steering angle sen- SST446B sor connector and control unit connector, and reconnect them fs firmly. Conduct self-diagnosis.

YYMONITOR ¥YNO FAIL

CAR SPEED (REF)

Okm/h- N.G. 3) v

STEERING ANG

L8° N.G.

NEUTRAL SIG

ON

CHECK STOP LAMP IN-

> Malfunctioning stop lamp switch OFF

STOP LAMP SW

PUT SIGNAL.

system

PKB/CLUTCH SW

ON ls Set CONSULT in DATA

ON

NEUTRAL SW

ENG REV

UNDER 1500 MONITOR mode.

RO.O0A ON-OFF display OFF FAILSAFE/V = OR RECORD | &) Check that stop lamp in- put is present at control [4] vy MONITOR $¥.NO FAIL unit. NON FAILSAFE Brake ON:

HICAS SOL

WARNING LAMP

OFF Approximately 12V Brake OFF: OV yok. O.K.

CHECK STEERING NEU-

»| Replace control unit. L RECORD r

TRAL POSITION SENSOR

INPUT SIGNAL.

Set CONSULT in DATA SST728B MONITOR mode. 46 Oe ON-OFF display OR Check that steering neu- tral input is present at fe) Oo mpd 1 td 24) control unit when steer- ing wheel is turned to the left and right at least 20° R/G B from the neutral position. [Vv | Neutral position: + D © Approximately 5V SST733B When turned at least 20°: OV 4€ G) & |N.G. v ® {e) 7 0 1 24]

Y/B B LV —8 9 SST734B ST-70

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.