Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Inspection (Cont'd) If both cylinder block and piston are replaced with new Piston grade number ones, select piston of the same grade number punched on cylinder block upper surface.

SEM257C Measure piston skirt diameter. Piston diameter “A”’: Refer to S.D.S. Measuring point ‘“‘a’’ (Distance from the top): 52 mm (2.05 in) Check that piston-to-bore clearance is within specification. Piston-to-bore clearance ‘“‘B”’:

0.020 - 0.040 mm (0.0008 - 0.0016 in)

SEM258C

5. Determine piston oversize according to amount of cylinder wear. Oversize pistons are available for service. Refer to S.D.S.

6. Cylinder bore size is determined by adding piston-to-bore clearance to piston diameter ‘‘A’’. Rebored size calculation: D=A+B-C where, D: Bored diameter A: Piston diameter as measured B: Piston-to-bore clearance C: Honing allowance 0.02 mm (0.0008 in) Install main bearing caps, and tighten to the specified torque to prevent distortion of cylinder bores in final assembly. Cut cylinder bores. When any cylinder needs boring, all other cylinders must also be bored. Do not cut too much out of cylinder bore at a time. Cut only

0.05 mm (0.0020 in) or so in diameter at a time. Hone cylinders to obtain specified piston-to-bore clearance. . Measure finished cylinder bore for out-of-round and taper. Measurement should be done after cylinder bore cools down.

EM-41

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.