Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Inspection (Cont'd)

3. Measure crankshaft runout. Runout (Total indicator reading): Less than 0.04 mm (0.0016 in)

BEARING CLEARANCE

e Either of the following two methods may be used, however, method ‘‘A’’ gives more reliable results and is preferable. Method A (Using bore gauge & micrometer) Main bearing

1. Set main bearings in their proper positions on cylinder block and main bearing cap. .

SEM448C

2. Install main bearing cap to cylinder block. Of Tighten all bolts in correct order in two or three stages. Refer to ‘‘Assembly”’. O

3. Measure inner diameter ‘‘A’’ of each main bearing. e) e)S orf WA \ SEM252C

4. Measure outer diameter ‘“‘Dm”’ of each crankshaft main journal.

5. Calculate main bearing clearance. Main bearing clearance = A—Dm Standard:

0.020 - 0.047 mm (0.0008 - 0.0019 in) Limit: 0.1 mm. (0.004 in) ® NN If it exceeds the limit, replace bearing. If clearance cannot be adjusted within the standard of any bearing, grind crankshaft journal and use undersized bear- ing.

a. When grinding crankshaft journal, confirm that “L’’ dimen- sion in fillet roll is more than the specified limit. “L”’: 0.1 mm (0.004 in)

b. Refer to S.D.S. for grinding crankshaft and available ser- vice parts.

SEM964 EM-39

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.