Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Avoid open flame - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Avoid open flame - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXAvoid open flame - Nissan 240SX 1991-1992 Workshop Manual

Avoid open flame

PRECAUTIONS Precautions for the Handling of Refrigerant Do not release refrigerant into the air. Use your refrigerant e recycling equipment to capture the refrigerant every time you need to discharge an air conditioning system. The release of refrigerant into the air can cause damage to the Earth’s ozone layer.

RHA576C Do not release. No direct heat on container

point Valve pr ess Pp

Avoid open flame

i Gloves / EY A (Lg //) oD RHA475C Always wear eye protection when working around the system. Always be careful that refrigerant does not come in contact with your skin. Keep refrigerant containers stored below 40°C (104°F) and never drop from high places. Work in well-ventilated area because refrigerant gas evaporates quickly and breathing may become difficult due to the lack of oxygen. Keep refrigerant away from open flames because poisonous gas will be produced if it burns. e Do not increase can temperature beyond 40°C (104°F) in charging. e Do not heat refrigerant container with an open flame. There is a danger that container will explode. e@

CAUTION: Do not use steam to clean surface of condenser or evaporator. Be sure to use cold water or com- e pressed air. . Donotuse compressed air to clean out a contaminated A/C tube or hose. Shake the line over a clean, e white paper towel. If it contains obvious moisture or contaminants, replace it. Do not blow out the line with refrigerant.

HA-3

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.