Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 29 (Cont'd)

Non-California model

INSPECTION START

Is lifted ol Vv up and down.

CHECK OVERALL FUNCTION.

INSPECTION END

—~ wr 1) Start engine and warm it up sufficiently. 2) Make sure that E.G.R. control valve spring is lifted up and SEF9391 down when racing engine Cae (2,000 rpm). (Use your finger.) Is not lifted up and down. Y O.K.

CHECK VACUUM SOURCE TO

CHECK COMPONENTS

Vv

E.G.R. CONTROL VALVE.

(E.G.R. control valve and B.P.T. 1) Disconnect vacuum hose to valve). E.G.R. control valve. Refer to “Electrical Components Vacuum hose connected 2) Make sure that vacuum exists Inspection’. to E.G.R. control valve MEF694A under the following condi- (See page EF & EC-185.) tions. N.G. [

CAINIT [0] CONNECTOR ]

At idle: €> Vacuum should not exist. v 105 Engine speed is about 2,000 L_ @ Replace malfunctioning compo- rpm: nent(s). Vacuum should exist. ye O.K.

CHECK CONTROL FUNCTION.

CHECK VACUUM HOSE.

v 1) Check voltage between E.C.U. 1) Check vacuum hose for clog- terminald@o5and ground under ging, cracks and proper con- the following conditions. nection. Voltage: C= - At idle Approximately 0V Split Engine speed is about 2,000 rpm. Battery voltage yNG. N.G.

CHECK POWER SUPPLY.

Check the following.

—~ e Harness connectors(9), 1) Stop engine. 2) Disconnect E.G.R. & canister e 10A fuse SEF816F e Harness continuity between control solenoid valve har- E.G.R. & canister control sole- ness connector. 3) Turn ignition switch ‘‘ON”’. noid valve and fuse 4) Check voltage between termi- If N.G., repair harness or con- nal () and ground. nectors. (Ge) | Voltage: Battery voltage 2 low vo) ®

AN Improper connection

MEF606A

EF & EC-124

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.