Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REAR WINDOW DEFOGGER - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REAR WINDOW DEFOGGER - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREAR WINDOW DEFOGGER - Nissan 240SX 1991-1992 Workshop Manual

REAR WINDOW DEFOGGER

REAR WINDOW DEFOGGER

Filament Repair

REPAIR EQUIPMENT

1. Conductive silver composition (Dupont No. 4817 or equiva- lent) Ruler 30 cm (11.8 in) long wn Drawing pen Heat gun Alcohol Oar Cloth

REPAIRING PROCEDURE

1. Wipe broken heat wire and its surrounding area clean with a (0.20) 5 (0.20) 5 Break cloth dampened in alcohol. PT Heat wire ~~

2. Apply a small amount of conductive silver composition to tip of IwA4 drawing pen. Shake silver composition container before use. 1h

3. Place ruler on glass along broken line. Deposit conductive silver composition on break with drawing pen. Slightly overlap Ruler existing heat wire on both sides [preferably 5 mm (0.20 in)] of Drawing pen Unit: mm (in) the break. BE540 r

4. After repair has been completed, check repaired wire for Repaired point continuity. This check should be conducted 10 minutes after silver composition is deposited. Do not touch repaired area while test is being conducted.

@ | —_, SELO12D

5. Apply a constant stream of hot air directly to the repaired r Repaired point area for approximately 20 minutes with a heat gun. A minimum distance of 3 cm (1.2 in) should be kept between |L repaired area and hot air outlet. If a heat gun is not available, let the repaired area dry for 24 hours.

Heat gun SELO13D

EL-81

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.