Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ENGINE COOLING SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ENGINE COOLING SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXENGINE COOLING SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

ENGINE COOLING SYSTEM

ENGINE COOLING SYSTEM

Thermostat

From heater pipe

From radiatoree

Liquid gasket application places

| Liquid gasket Liquid gasket SLC537A

INSPECTION

1. Check valve seating condition at ordinary room tempera- tures. It should seat tightly.

2. Check valve opening temperature and maximum valve lift.

Standard
Valve opening temperature°C (°F)76.5 (170)
Maximum valve liftmm/°C (in/°F)10/90 (0.39/194)

Then check if valve is closed at 5°C (9°F) below valve SLC343 opening temperature. Apply a continuous bead of liquid gasket to mating surface of water inlet. Refer to ‘Water Pump”’. After installation, run engine for a few minutes, and check for leaks. Be careful not to spill coolant over engine compartment. Use a rag to absorb coolant.

LC-10

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.