Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

Control Valve Assembly (Cont'd)

ASSEMBLY

1.

Install upper and lower bodies.

Place oil circuit of upper body face up. Install steel balls in

a.

their proper positions.

b. Install reamer bolts from bottom of upper body and install

separate gaskets.

(long) 9 So 0a %O ° Qe Mog ono 000, 90 oo

paee of De

25° p °, Oe 00 Oo e Uo 0 0° Kom o ° eg oe 0 (¢) C100 Oo 0 © ° 000 °0 ° °

Reamer bolt (short) SAT681A

Place oil circuit of lower body face up. Install orifice check

c.

spring, orifice check valve and pilot filter.

SAT682A

d. Install lower separate gaskets and separator plates on lower

body.

Install and temporarily tighten support plates, fluid tempera-

e.

ture sensor and tube brackets.

Bolt length:

27 (1.06)

Unit: mm (in)

SAT197B

AT-130

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.