Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Inspection (Cont’d) CONNECTING ROD BUSHING CLEARANCE (Small end)

1. Measure inner diameter ‘‘C”’ of bushing.

SEM151B Measure outer diameter ‘‘Dp”’ of piston pin. Calculate connecting rod bushing clearance. on C-Dp =

0.005 - 0.017 mm (0.0002 - 0.0007 in) (Standard)

0.023 mm (0.0009 in) (Limit) If it exceeds the limit, replace connecting rod assembly and/or piston set with pin.

Micrometer SEM903A REPLACEMENT OF CONNECTING ROD BUSHING (Small end)

1. Drive in small end bushing until it is flush with end surface of rod. Be sure to align the oil holes.

2. After driving in small end bushing, ream the bushing so that clearance between small end bushing and piston pin is specified valve. Clearance between small end bushing and piston pin:

0.005 - 0.017 mm (0.0002 - 0.0007 in) SEM062A

FLYWHEEL/DRIVE PLATE RUNOUT

Runout (Total indicator reading): Flywheel (M/T model) Less than 0.15 mm (0.0059 in) Drive plate (A/T model) Less than 0.5 mm (0.020 in)

Dial gauge SEM261C Assembly PISTON

1. Install new snap ring on one side of piston pin hole.

SEM166B EM-45

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.