CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
CYLINDER BLOCK
CYLINDER BLOCK
CAUTION: When installing sliding parts such as bearings and pistons, be sure to apply engine oil on the sliding surfaces. e Place removed parts such as bearings and bearing caps in their proper order and direction. e When tightening connecting rod bolts and main bearing cap bolts, apply engine oil to thread portion of bolts and seating surface of nuts.
Engine front Disassembly
PISTON AND CRANKSHAFT
$T0501S000 we
> meet
A — ) Place engine on a work stand.
1. CoeT SR |
2. Remove timing chain. f&, \O \\ Refer to ““Removal”’ in “TIMING CHAIN”. eve KV 10105001 ( — ) / SEM376D
3. Remove pistons with connecting rods. e When disassembling piston and connecting rod, remove Piston heater snap rings, then heat piston to 60 to 70°C (140 to 158°F) or use piston pin press stand at room temperature.
CAUTION: | e When piston rings are not replaced, make sure that piston rings are mounted in their original positions. e@ When piston rings are being replaced and no punchmark is present, piston rings can be mounted with either side up. SEM877B
EM156
4. Remove main bearing beam and crankshaft. e Before removing main bearing beam, measure crankshaft end play. e Bolts should be loosened in two or three steps.
® @ © @ @. Loosen in numerical order. . . ) _ SEM248C EM-35
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.