Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

PRECAUTIONS AND PREPARATION - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › PRECAUTIONS AND PREPARATION - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXPRECAUTIONS AND PREPARATION - Nissan 240SX 1991-1992 Workshop Manual

PRECAUTIONS AND PREPARATION

PRECAUTIONS AND PREPARATION

Precautions @ Before disasseinbly, thoroughly clean the outside of the unit. @ Disassembly should be done in a clean work area. It is important to prevent the internal parts from becoming contaminated by dirt or other foreign matter. @ When disassembling parts, be sure to place them in order in a parts rack so they can be reinstalled in their proper positions. @ Use nylon cloths or paper towels to clean the parts; common shop rags can leave lint that might interfere with their operation. @ Before inspection or reassembly, carefully clean all parts with a general purpose, non-flammable solvent. @ Before assembly, apply a coat of recommended A.T.F.* to hydraulic parts. Vaseline may be applied to O-rings and seals. Do not use any grease. . @ Replace all gaskets, seals and O-rings. Avoid damaging O-rings, seals and gaskets during installation. Perform functional tests whenever designated. *: Automatic transmission fluid

Preparation

SPECIAL SERVICE TOOLS

Tool] number
(Kent-Moore No.) Tool nameDescription
Tool name
KV48100700 (J26364)Measuring pinion rotating torque
(J26364) Torque adapter6torque
$T27180001Removing and installing
(J25726-A)steering wheel
Steering wheel puller
HT72520000sanRemoving ball joint
(J25730-A)
Ball joint remover
$T27091000Measuring oil pressure
(J26357)
Pressure gauge
KV48102500 )Measuring oil pressure
( - ) Pressure gauge adapter

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.