REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
REPAIR FOR COMPONENT PARTS
REPAIR FOR COMPONENT PARTS
Oil Pump (Cont'd)
d. Assemble cam ring, cam ring spring and spring seat. Install spring by pushing it against pump housing.
e. While pushing on cam ring install pivot pin.
SAT651A Install rotor, vanes and vane rings.
3. @ Pay attention to direction of rotor.
Install oil pump housing and oil pump cover.
4.
a. Wrap masking tape around splines of oil pump cover assembly to protect seal. Position oil pump cover assembly in oil pump housing assembly, then remove masking tape.
b. Tighten bolts in a criss-cross pattern.
SAT649A Install seal rings carefully after packing ring grooves with
5. petroleum jelly. Press rings down into jelly to a close fit.
@ Seal rings come in two different diameters. Check fit
© Es ©) carefully in each groove. Small dia. . . seal rings Small dia. seal ring: @) ee ee
No mark
3
Large dia.
seal rings Large dia. seal ring: ¢ ya Yellow mark in area shown by arrow @ Do not spread gap of seal ring excessively while installing. . . . . . —— A ry) : — TSS S52 S
It may deform ring.
SAT663A AT-118
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.