STARTING SYSTEM — Starter — - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › STARTING SYSTEM — Starter — - Nissan 240SX 1991-1992 Workshop Manual
STARTING SYSTEM — Starter —
STARTING SYSTEM — Starter —
Brush Check (Cont'd)
BRUSH HOLDER
1. Perform insulation test between brush holder (positive side) and its base (negative side). @ Continuity exists. ... Replace.
2. Check brush to see if it moves smoothly.
If brush holder is bent, replace it; if sliding surface is dirty,
@ clean.
SEL627B
Pole Piece Check
Holder Pole piece is secured to yoke by bonding agent. Check pole piece to see that it is secured to yoke and for any cracks. Replace malfunctioning parts as an assembly. Holder may move slightly as it is only inserted and not bonded.
CAUTION: Do not clamp yoke in a vice or strike it with a hammer.
Armature Check
1. Continuity test (between two segments side by side). @ No continuity ... Replace. |
SEL625B
2. Insulation test (between each commutator bar and shaft). @ Continuity exists. ... Replace.
Ohmmeter 3: i lee SEL104E
3. Check commutator surface. @ Rough ... Sand lightly with No. 500 to 600 sandpaper.
SEL624B
EL-19
Parts & tools for this job For Nissan 240SX
- TOOLBattery testerSearch: car battery tester
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBattery terminal cleanerSearch: battery terminal cleaner
As an Amazon Associate we earn from qualifying purchases.