SERVICE PROCEDURES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › SERVICE PROCEDURES - Nissan 240SX 1991-1992 Workshop Manual
SERVICE PROCEDURES
SERVICE PROCEDURES
Condenser and Condenser Fan Motor (Cont’d)
REMOVAL Remove engine air inlet duct. Remove air filter assembly. Remove radiator top mounting bracket. Remove harness clips from top shroud. Move vacuum hoses and harness behind the back edge of aAPwWNnN> shroud. @® “N Remove radiator reservoir hose. Remove undercover.
Remove the two bottom shroud mounting screws. vi Remove the two top shroud mounting screws. shroud Disassemble top shroud from bottom shroud (two clips each side), and from side shroud pieces (one clip each side), then remove top shroud. Remove resonator tank from bottom shroud.
11. Disassemble side shroud pieces from bottom shroud (one
12. clip each side) and remove the two side shroud pieces.
13. Disconnect condenser fan motor harness connector. Remove condenser fan motor from bottom of radiator. 14,
Resonator a tank
15. Unhoock (by pressing on the tabs) and remove narrow semi-circle lower part of shroud.
16. Remove bottom shroud.
CAUTION: Be careful not to damage radiator.
Semi-circular shroud
RHA212C HA-39
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.