Disassembly (Cont’d) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Disassembly (Cont’d) - Nissan 240SX 1991-1992 Workshop Manual
Disassembly (Cont’d)
DISASSEMBLY
Disassembly (Cont’d)
b. Apply compressed air to oil hole until band servo piston comes out of transmission case. @ Hold piston with a rag and gradually direct air to oil hole.
c. Remove return springs.
d. Remove springs from accumulator pistons B, C and D.
e. Apply compressed air to each oil hole until piston comes out. @ Hold piston with a rag and gradually direct air to oil hole.
| Identification of accumulator pistons | A | B | C | D |
|---|---|---|---|---|
| Identification of oil holes | a | b | Cc | d |
A B C D SAT040B
f. Remove O-ring from each piston. Front => (34,.NR) (2-43) Accumulator Accumulator piston B piston D
(1-2) (ND) Accumulator Accumulator piston C piston A SAT937A
21. Remove manual shaft components, if necessary.
a. Hold width across flats of manual shaft (outside the trans- mission case) and remove lock nut from shaft.
SAT041B
b. Remove retaining pin from transmission case. Manual plate Oil seal Retaining pin 0
k? iy) -
Lock nut om Transmission case [ SAT042B
AT-119
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.