Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ADJUSTMENT (Model R200V) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ADJUSTMENT (Model R200V) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXADJUSTMENT (Model R200V) - Nissan 240SX 1991-1992 Workshop Manual

ADJUSTMENT (Model R200V)

ADJUSTMENT (Model R200V)

Side Bearing Preload (Cont'd)

5. Install the side bearing caps in their correct locations and torque the bearing cap retaining bolts. Specification: 88 - 98 N-m (9 - 10 kg-m, 65 - 72 ft-lb)

6. Turn the carrier several times to seat the bearings.

Measure the turning torque of the carrier at the ring gear

7. retaining bolts with a spring gauge, J-8129. Specification:

34.3 - 39.2 N (3.5 - 4 kg, 7.7 - 8.8 Ib) of pulling force at the ring gear bolt

If the carrier turning torque is not within the specification range, increase or decrease the total thickness of the side bearing adjusting washers until the turning torque is cor- rect. If the turning torque is less than the specified range, install washers of greater thickness; if the turning torque is greater than the specification, install thinner washers. See the S.D.S. section for washer dimensions and part num- bers. Record the total amount of washer thickness required for the correct carrier side bearing preload.

10. Remove the carrier from the final drive housing, saving the selected preload washers for later use during the assembly Tool of the final drive unit.

PD344

Pinion Gear Height and Pinion Bearing Preload

1. Make sure all parts are clean and that the bearings are well lubricated.

2. Assemble the pinion gear bearings into the pinion preload shim selector Tool, J-34309.

SPD769 PD-37

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.