Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual

DISCHARGING, EVACUATING, CHARGING AND CHECKING

DISCHARGING, EVACUATING, CHARGING AND CHECKING

Confirmation of Amount of Charged Refrigerant

The amount of refrigerant charged into the system can be observed through the sight glass by watching the flow of the refrigerant and by reading the high pressure and low pressure manifold gauges under the following conditions: CONDITIONS Doors: Close completely. e Window glasses: Close completely. e Intake door position: RECIRC e Mode door position: VENT e Blower fan: HI @ TEMP control: Optional (Set so that intake air temperature is 30 to 35°C (86 to 95°F). e AIR CON switch: ON e Engine speed: Approx. 1,500 rpm

WORK PROCEDURE

Engine speed: Approx. 1,500 rpm : After warming up engine, adjust intake air temperature to 30 to 35°C (86 to 95°F). Wait until high pressure is stabilized at approx. 1,471 kPa (15 kg/cm”, 213 psi).*1 *1: Cover the entire condenser until the required pressure is indicated. Vv Check the sight glass of the refrigerant sys- tem.*2 Touch the high and low pressure tubes of the system to get an idea of the temperature. *2: Refer to sight glass inspection. Vv N.G. Check to see whether the refrigerant If white clouding or bubbles are found: Vv is free of white clouding and bubbles. O.K. y Recover the refrigerant from the A/C system. Recharge the system to specification using an accurate refrigerant measuring device.

Vv Charged amount of refrigerant is O.K.

HA-34

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.