Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Electrical Components Inspection (Cont'd)

e@ Check plunger for seizing or sticking. e@ Check for broken spring.

SEF747K

DETONATION SENSOR

1. Disconnect detonation sensor sub-harness connector. 34 Detonation sensor

(alb} terminal

2. Check continuity between terminal @ and ground. TS. Continuity should exist. DISCONNECT € e It is necessary to use an ohmmeter which can measure more than 10 MQ. a SEF854J INJECTOR DISCONNECT ae

1. Disconnect injector harness connector.

2. Check resistance between terminals as shown in the figure. Resistance: Approximately 11 [at 20°C (68°F)] If N.G., replace injector.

NEUTRAL SWITCH

Check continuity between terminals as shown in the figure.

ConditionsContinuity
Shift to neutral positionYes
Shift to other positionNo

~ Back-up lamp If N.G., replace neutral switch. switch OtSCOMMECT &> O.D. switch Neutral switch SEF343H INHIBITOR SWITCH (A/T models) Check continuity between terminals @ and @.

ConditionsContinuity
Shift to ‘‘P’’ on ‘‘N”’ positionYes
Shift to other positionNo

If N.G., replace inhibitor switch. Refer to section AT. SEF236L EF & EC-168

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.