Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual

DISCHARGING, EVACUATING, CHARGING AND CHECKING

DISCHARGING, EVACUATING, CHARGING AND CHECKING

Confirmation of Amount of Charged Refrigerant (Cont'd)

Amount of Overcharged, or charge Appropriate Refrigerant is insufficient Almost no refrigerant air in system Check item Temperature of high and High pressure side is hot High pressure side is No difference is felt be- High pressure side is very low pressure pipes while low pressure side is warm and low pressure tween high and low hot. cold. side is somewhat cold. presser sides. Flow of refrigerant viewed Mostly transparent. Bubbles are always flow- Nothing is visible. If overcharged, no bub- through sight glass Occasionally some bub- ing. Refrigerant is cloudy. bles are seen. If there is bles are seen when en- air in the system, large gine rpm is increased or bubbles are seen. decreased.

ia

Pressure Normal high pressure: Both high and low pres- High pressure value is Both high and low pres- 1,373 - 1,765 kPa sure values are insuffi- very small. Sure values are exces- (14 - 18 kg/cm?, cient. sive. 199 - 256 psi) Normal low pressure: 147 - 294 kPa (1.5 - 3 kg/cm?, 21 - 43 psi) Action to take Air bubbles may be gen- Add refrigerant after Check the refrigerant sys- Stop the compressor and erated when the receiver checking for leaks. tem. extract excessive refriger- drier strainer is clogged, ant. If air is found, per- or when the expansion form evacuation, then valve is opened exces- charge the specified sively. amount of refrigerant.

CAUTION:

The condition of bubbles seen through the sight glass as well as

the intake and discharge pressures are influenced by the

ambient temperature, wind velocity, weather, and by the air

temperature in front of the condenser, etc.

HA-37

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.