AXLE HOUSING - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › AXLE HOUSING - Nissan 240SX 1991-1992 Workshop Manual
AXLE HOUSING
REAR AXLE — Wheel Hub and Axle Housing Disassembly (Cont'd)
AXLE HOUSING
@ Attach a drift on outer shell of bushing as shown in figure at
left, remove bushing using arm bushing remover. When placing axle housing in a vise, use wooden blocks or copper plates as pads.
SRA111A @ Ensure axle housing bore is free from scratches or de- formities before pressing bushing into it. @ Attach bushing to chamfered bore end of axle housing and press it until it is flush with end face of axle housing.
SRA112A Inspection
WHEEL HUB AND AXLE HOUSING
@ Check wheel hub and axle housing for cracks by using a magnetic exploration or dyeing test. @ Check wheel bearing for damage, seizure, rust or rough operation. @ Check rubber bushing for wear or other damage. Replace if necessary.
Press. Assembly ¥ Drift
Place hub on a block. Attach a drift to inner race of wheel bearing
and press it into hub as shown in figure at left. Be careful not to damage grease seal.
Drift WW)
SRA113A RA-12
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.