Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 11

Revolution sensor

Sk op

77> OFF See ene igaa | SYMPTOM: A/T does not shift from D; to D. at the Shift solenoid B specified speed. Self-diagnosis Fluid start eal Are Diagnostic Procedures 7 and | No > Go to Diagnostic Procedure 7 or p fl Light 8 0.K.?

8. Yes ---

--Shade a

v y; — Does self-diagnosis show damage PS .| Check damaged circuit. — Refer 3 Light | | to inhibitor switch, overdrive to “'Self-diagnosis”. SAT751®1 | switch, shift solenoid A, B, A Throttle sensor and 7 | | v~ revolution sensor, speed sensor al throttle valve switch or fluid temperature sensor = S p circuit after cruise test? No rN

Check throttle sensor. — Refer

|S: >| Repair or replace throttle sensor.

/ p Vv to section EF & EC. ' ‘ \ N.G.

1. Remove oil pan. Air duct — SAT739D

2. Check A/T fluid condition. ”| | 1. Remove control valve assem- bly. — Refer to ‘““ON-VEHI- OK.

CLE SERVICE”.

*1 2. Check the following items. @ Shift valve B O.K. @ Overrun clutch control valve @ Shift solenoid B < O.K. |} Pilot valve @ Pilot filter

3. Disassemble A/T.

4. Check the following items. SAT1718 @ Servo piston assembly Brake band @® 4 8/8 Ib 2 @ Torque converter @ Oil pump assembly NS 4 Vv G

N. -»| 1. Perform A/T control unit

Check again.

(D5) 'D,) input/output signal inspection.

2. If N.G., recheck A/T control y — x unit pin terminals for damage

INSPECTION END

or connection of A/T control 0/8 Y tt SAT120B unit harness connector.

AT-64

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.