Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

Oil Pump (Cont’d) Side clearances Dial indicator @ Measure side clearances between end of oil pump housing and cam ring, rotor, vanes and control piston in at least four Straight edge places along their circumferences. Maximum measured val- { ues should be within specified ranges. i r Ty @ Before measuring side clearance, check that friction rings, =o O-ring, control piston side seals and cam ring spring are Control removed. piston Oil pump Standard clearance: Cam ring Rotor Nousing Cam ring Vane

0.01 - 0.024 mm (0.0004 - 0.0009 in) SAT657A Rotor, vanes, control piston

0.03 - 0.044 mm (0.0012 - 0.0017 in) @ If not within standard clearance, replace oil pump assembly except oil pump cover assembly.

Seal ring clearance Lye — Seal rin Clearance

Measure clearance between seal ring and ring groove.

@ Standard clearance:

NS UY)

0.10 - 0.25 mm (0.0039 - 0.0098 in) Wear limit: =

0.25 mm (0.0098 in)

If not within wear limit, replace oil pump cover assembly.

@

| SAT658A ASSEMBLY Drive oil seal into oil pump housing.

1. @ Apply A.T.F. to outer periphery and lip surface. $T33200000 (J26082)

SATO81E Install cam ring in oil pump housing by the following steps.

2. Install side seal on control piston.

a. Pay attention to its direction — Black surface goes toward @ control piston. e@ Apply petroleum jelly to side seal. Install control piston on oil pump.

b.

AT-123

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.