Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Final Check (Cont'd)

5. Start engine and measure line pressure at idle and stall speed. @ When measuring line pressure at stall speed, follow’ the stall test procedure.

Line pressure:

Engine speedLine pressure kPa (kg/cm7?, psi)
rpmD, 2 and 1 rangesR range
‘dle422 - 461677-716
(4.3 - 4.7, 61 - 67)(6.9 - 7.3, 98 - 104)
Stall1,020 - 1,0981,422 - 1,500
(10.4 - 11.2, 148- 159) | (14.5 - 15.3, 206 - 218)

SAT643A

JUDGEMENT OF LINE PRESSURE TEST

JudgementSuspected parts
Line pressure is low in all ranges.Oil pump wear
Control piston damage
Pressure regulator valve or plug sticking
Spring for pressure regulator valve damaged
Fluid pressure leakage between oil strainer and pressure regulator
valve
Line pressure is low in particular range.Fluid pressure leakage between manual valve and particular clutch.
For example;
idleIf line pressure is low in ““R” and “1” ranges but is normal in
At“D" and “‘2"' range, fluid leakage exists at or around low & reverse
brake circuit.
Line pressure is high.Mal-adjustment of throttle sensor
Fluid temperature sensor damaged
Line pressure solenoid sticking
Short circuit of line pressure solenoid circuit
Pressure modifier valve sticking
Pressure regulator valve or plug sticking
Line pressure is low.Mal-adjustment of throttle sensor
Control piston damaged
speedLine pressure solenoid sticking Short circuit of line pressure solenoid circuit
Short circuit of line pressure solenoid circuit
stallPressure regulator valve or plug sticking
AtPressure modifier valve sticking
Pilot valve sticking

AT-79

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.