Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual

REAR AXLE — Drive Shaft

REAR AXLE — Drive Shaft

Side flange

Drive shaft @@_ -

(0) 34-44 (3.5 - 4.5, 25 - 33)

(21 - 28, 152 - 203)| (OC) 206 - 275

0) : N-m (kg-m, ft-lb) Adjusting cap SRA380A Removal \A Side flange When removing drive shaft, cover boots with shop towel to yY prevent damage to them.

FINAL DRIVE SIDE

Remove side flange mounting bolt and separate shaft.

Z” SRA115A

WHEEL SIDE

eee 6 Pi Remove drive shaft by lightly tapping it with a copper hammer. ae To avoid damaging threads of drive shaft, install a nut while removing drive shaft.

SRA116A Installation @ Insert drive shaft from wheel hub and temporarily tighten wheel bearing lock nut. @ Tighten side flange mounting bolts to specified torque. @ Tighten wheel bearing lock nut to specified torque.

RA-13

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.