REAR SUSPENSION MEMBER - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REAR SUSPENSION MEMBER - Nissan 240SX 1991-1992 Workshop Manual
REAR SUSPENSION MEMBER
REAR SUSPENSION — Multi-link and Lower Ball Joint
Removal and Installation @ Refer to ‘Removal and Installation’ of REAR SUSPENSION. Before removing, put matchmarks on adjusting pin. @ When installing, final tightening must be carried out at curb weight with tires on ground. @ After installation, check wheel alignment. Refer to ‘‘Rear Wheel Alignment” of ON-VEHICLE SERVICE.
SRA129A SSN, ey, Matchmarks
(Pz SRA130A Inspection
REAR SUSPENSION MEMBER
en torque Replace suspension member assembly if cracked or deformed or if any part (insulator, for example) is damaged.
UPPER AND LOWER LINKS
Replace upper or lower link as required if cracked or deformed or if bushing is damaged. Swing force
SUSPENSION LOWER BALL JOINT
Vertical end play Measure swing force, turning torque and vertical end play in SRA131A @
axial direction. (Use same measurement procedures as that of
FA section.) If ball stud is worn, play in axial direction is excessive, or joint @ is hard to swing, replace lower arm.
| Swing force | 12.7 -90.2 N | |
|---|---|---|
| Swing force | 12.7 -90.2 N (1.3 - 9.2 kg, 2.9 - 20.3 Ib) | |
| Ball joint Lee ae specifications | Turning torque | 0.5 - 3.4 N-m (5 - 35 kg-cm, 4.3 - 30.4 in-Ib) |
| Vertical end play | 0 mm (0 in) |
RA-22
Parts & tools for this job For Nissan 240SX
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTRear shock absorbersSearch: Nissan 240SX rear shock absorbers
As an Amazon Associate we earn from qualifying purchases.