Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ON-VEHICLE INSPECTION (Power steering) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ON-VEHICLE INSPECTION (Power steering) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXON-VEHICLE INSPECTION (Power steering) - Nissan 240SX 1991-1992 Workshop Manual

ON-VEHICLE INSPECTION (Power steering)

ON-VEHICLE INSPECTION (Power steering)

Checking and Adjusting Drive Belts

Refer to section MA for Drive Belt Inspection.

Checking Fluid Level

F) Check fluid level. —— 176° F) - (122 Fluid level should be checked using “‘HOT” range on dipstick at 86° - fluid temperatures of 50 to 80°C (122 to 176°F) or using ‘““COLD”’ 50-80°C HOT: range on dipstick at fluid temperatures of 0 to 30°C (32 to 86°F). HOT 0-30°C (32

COLD: ~|

[COLD

CAUTION: O.K. @ Do not overfill. "| O.K. (4 @ Recommended fluid is Automatic Transmission Fluid ‘‘DEX- . RONTM” type. SST280B

Checking Fluid Leakage

Check the lines for improper attachment and for leaks, cracks, damage, loose connections, chafing or deterioration.

1. Run engine at idle speed or 1,000 rpm. Make sure temperature of fluid in oil tank rises to 60 to 80°C (140 to 176°F).

2. Turn steering wheel right-to-left several times.

3. Hold steering wheel at each “‘lock’’ position for five seconds and carefully check for fluid leakage.

CAUTION: Do not hold the steering wheel in a locked position for more SST107B than 15 seconds.

4. If fluid leakage at connectors is noticed, loosen flare nut and then retighten. Do not overtighten connector as this can damage O-ring, washer and connector.

Bleeding Hydraulic System

1. Raise front end of vehicle until wheels clear ground.

2. Add fluid into oil tank to specified level. Meanwhile, quickly turn steering wheel fully to right and left and lightly touch steering stoppers. Repeat steering wheel operation until fluid level no longer decreases.

3. Start engine. Repeat step 2 above. @ Incomplete air bleeding will cause the following to occur. When this happens, bleed air again. ST-7

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.