Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual

DISCHARGING, EVACUATING, CHARGING AND CHECKING

DISCHARGING, EVACUATING, CHARGING AND CHECKING

Charging Refrigerant (Cont’d)

PRELIMINARY CHARGING OF REFRIGERANT-2

td gt — 7 -Sight

1. Slowly open the high pressure side valve of the manifold tt glass ye OT gauge to charge refrigerant from the high pressure side. ys

2. Close the high pressure valve after charging approx. 200 g tt TT (7.05 oz) refrigerant. ty fT

CAUTION: The refrigerant in the charging cylinder is kept in the liquid

TF fF F To

FT FP TT state, so the refrigerant should be charged from high pressure side. Do not start the engine with the high pressure valve kept TY TT open. T?,rrr?ysfyYyrtty “TT TT YF RHA682B

PRELIMINARY CHECK FOR REFRIGERANT LEAKS

Refer to ‘PRELIMINARY CHECK FOR REFRIGERANT LEAKS” in “Charging Refrigerant’.

CHARGING REFRIGERANT

1. Slowly open the high pressure valve of the manifold gauge, and charge the calculated amount of refrigerant in ‘‘CAL-

CULATING CHARGING AMOUNT OF REFRIGERANT”.

CAUTION: The refrigerant in the charging cylinder is kept in the liquid state, so the refrigerant should be charged from high pressure side. Do not start the engine with the high pressure valve kept open.

2. Close the high pressure valve of the manifold gauge.

3. Make sure that the calculated amount of refrigerant is in the sight glass.

4. Close the charging cylinder outlet valve.

5.

Turn off the heater if it is on (when using heater equipped

type).

HA-33.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.