TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 25 (Cont’d)
INSPECTION START
[_]
w#NO FAIL
wMONITOR
87°C
ENG TEMP SEN
CHECK POWER SUPPLY.
N.G. . Repair harness or connectors. or 1) Start engine. 2) Read engine tempera- ture sensor signal in
“DATA MONITOR”
mode with CONSULT. RECORD Engine temperature SEF380J should gradually rise and reach more than 70°C (158°F) after en- gine warm-up. OR (c=/y 1) Disconnect engine (Yt
temperature sensor
harness connector. 2) Turn ignition switch
3) Check voltage between MEF688A terminal @ and ground. Voltage: Approximately 5V iB O.K. X
CHECK GROUND CIRCUIT.
N.G. ,| Repair harness or connectors. | 1) Turn ignition switch “OFF’’. eo 2) Check harness continuity be- tween terminal () and engine ground. Continuity should exist. MEF689A OK. Vv
CHECK COMPONENT
N.G. Replace engine temperature (Engine temperature sensor). sensor. Refer to “Electrical Components Inspection’. (See page EF & EC-183.) O.K. y Check E.C.U. pin terminals for damage or the connection of E.C.U. harness connector.
EF & EC-109
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.