TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 6 — Hard to Start or
Impossible to Start under Normal Conditions
N.G. Repair or replace.
CHECK BATTERY AND STARTER.
v Check battery and starter operation. (Refer to EL section.) O.K. v No
Check fuel pump and cir- SEF380I'
CHECK FUEL PRESSURE.
1. Pinch fuel feed hose with fingers. cuit. (See page EF & EC- 152.) -
2. When cranking the engine, is there 2 any pressure on the fuel feed hose? NV bh N\ Yes AS Vv Yes Check injector(s) for leak-
CHECK INJECTOR FOR LEAKAGE.
fr Fuel filter When pressing accelerator pedal fully, age. OhYXQ can you start the engine. C\ Nd) > No SY | 4 | Vv \ noting =
« Pinching fuel feed hose 3 Y
No - SEF740K
CHECK INJECTOR.
Check injectors and cir- Vv
1. Remove crank angle sensor from
cuits. 13]
engine. (Crank angle sensor harness
connector should remain connected.)
Ar)
2. Disconnect ignition coil harness con-
nector.
3. Turn ignition switch ON. (Do not start
engine.)
4. When rotating crank angle sensor
shaft, does each injector make an operating sound? Yes Ei v SEF 1441 N.G. Check ignition coil, power
CHECK IGNITION SPARK.
Vv transistor unit and cir-
1. Disconnect ignition wire from rocker cuits. (See page EF & cover.
2. Connect a known good spark plug to EC-114.) the ignition wire.
3. Place end of spark plug against a suitable ground and crank engine.
4. Check for spark. O.K. v SEF837K (Go to @ on next page.)
Ignition wire
4 Spark plug ~~ go i SEF282G
EF & EC-68
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.