WINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › WINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual
WINDSHIELD AND WINDOWS
WINDSHIELD AND WINDOWS
Back Window—Coupe
Construction and removal/reinstallation methods of back window are basically the same as those of windshield. For details of service procedures, refer to ‘““‘Windshield”’. The difference between windshield and back window is as follows: For sealant drying period, refer to ‘‘Drying Time for Sealant”’. For details of moldings, refer to ‘Exterior’.
Sealant quantity Molding fastener
Spacer BI
Dam rubber and spacer |D]
BI Vehicle Install molding fastener. When installing it, heat body panel and | center More than fastener to approx. 30 to 40°C (86 to 12 (0.47) Double-faced 104°F). Dam rubber 30 adhesive tape (1.18) L. Fastener A Fastener A 420/ . Body panel d (16.54) Panel Double-faced More than Double-faced adhesive tape 7 (0.28)
el Fastener B |
adhesive tape Unit: mm (in) Unit: mm (in) J
Install dam rubber and spacers with Upper and side portion Lower portion Dam rubber double-faced adhesive tape. (Body side) Vehicle center | a B ‘J | Spacer
Body panel ub vy '
Dam rubber
WA Double-faced |
{f: Spacer
adhesive tape
Double-faced
Dam rubber
mounting adhesive tape joint portion portion
SBF200E BF-63
Parts & tools for this job For Nissan 240SX
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Nissan touch up paint
- PARTPanel clip assortmentSearch: Nissan panel clips assortment
As an Amazon Associate we earn from qualifying purchases.