Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

SUPER HICAS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › SUPER HICAS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXSUPER HICAS - Nissan 240SX 1991-1992 Workshop Manual

SUPER HICAS

SUPER HICAS

Rear Wheel Alignment

TOE-IN

Draw a base line across the tread.

1.

After lowering rear of vehicle, move it up and down to eliminate

friction.

SMA123

2. Measure toe-in. Lines parallel to Measure distance ‘‘A’’ and ‘B” at the same height as hub center. center line of body Toe-in: Refer to S.D.S.

3. Adjust toe-in by varying length of power cylinder lower links. (1) Loosen lock nuts. (2) Adjust toe-in by turning lower links forward or backward.

Make sure both lower links are the same length. Standard length “L”: 185.5 mm (7.30 in) (3) Tighten lock nuts to the specified torque. (0): 37 - 46 Nem (3.8 - 4.7 kg-m, 27 - 34 ft-lb) @ Refer to ON-VEHICLE SERVICE for other procedures.

SRA260A

RA-24

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.