Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

“COMPRESSOR OIL’”’. - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › “COMPRESSOR OIL’”’. - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEX“COMPRESSOR OIL’”’. - Nissan 240SX 1991-1992 Workshop Manual

“COMPRESSOR OIL’”’.

PRECAUTIONS Precautions for Servicing Compressor Attach a blind plug to the suction port (low pressure) and e discharge port (high pressure) of the compressor to pre- vent oil from leaking out and dust from getting inside. Do not keep the compressor in the upside down position or e laid on its side for more than 10 minutes. When replacing or repairing the compressor, be sure to @ remove oil from the compressor and check the oil quantity extracted. When replacing with a new compressor, be sure to remove e@ oil from the new compressor so that the quantity of oil remaining in the new compressor is equal to the quantity collected from the removed compressor. See the section

“COMPRESSOR OIL’”’.

Pay attention so as not to allow dirt and oil to attach on the e friction surfaces between clutch and pulley. If the surface is contaminated with oil, wipe it off by using a clean waste cloth moistened with thinner. After completing the compressor service operation, be sure e to rotate the compressor shaft more than five turns in both directions by hand to equalize oil distribution inside the compressor, then run the compressor for about one hour by idling the engine. When the compressor magnet clutch has been replaced, be e@ sure to check the magnet clutch for normal operation by | applying voltage to the clutch.

HA-18

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.