REAR WINDOW DEFOGGER - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REAR WINDOW DEFOGGER - Nissan 240SX 1991-1992 Workshop Manual
REAR WINDOW DEFOGGER
REAR WINDOW DEFOGGER
Filament Repair
REPAIR EQUIPMENT
1. Conductive silver composition (Dupont No. 4817 or equiva- lent) Ruler 30 cm (11.8 in) long wh Drawing pen Heat gun Alcohol Cloth Oar
REPAIRING PROCEDURE
1. Wipe broken heat wire and its surrounding area clean with a (0.20) 5 (0.20) 5 4 ; { Break cloth dampened in alcohol. eat wi wire ZZ
2. Apply a small amount of conductive silver composition to tip of a drawing pen. aL —————"_ Shake silver composition container before use. +
3. Place ruler on glass along broken line. Deposit conductive silver composition on break with drawing pen. Slightly overlap Ruler existing heat wire on both sides [preferably 5 mm (0.20 in)] of Drawing pen Unit: mm (in) the break. BE540 r
4. After repair has been completed, check repaired wire for Repaired point continuity. This check should be conducted 10 minutes after — silver composition is deposited. Do hot touch repaired area while test is being conducted.
CO
OQ) SEL012D —_
5. Apply a constant stream of hot air directly to the repaired ' Repaired point area for approximately 20 minutes with a heat gun. A 1 minimum distance of 3 cm (1.2 in) should be kept between repaired area and hot air outlet. If a heat gun is not available, let the repaired area dry for 24 hours. —*
Heat gun SELO13D
- Ey ee eg
EL-82
Parts & tools for this job For Nissan 240SX
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Nissan touch up paint
- PARTPanel clip assortmentSearch: Nissan panel clips assortment
As an Amazon Associate we earn from qualifying purchases.