Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 39 (Cont’d)

INSPECTION START

Vv O.K.

INSPECTION END

CHECK OVERALL FUNCTION.

1) Turn ignition switch ‘‘ON”’. 2) Listen to fuel pump operating sound. Fuel pump should operate for 5 sec- onds after ignition switch is turned WY 0 “ON”. Fuel pump SEF9801 N.G. B) y : DISCONNECT am Wd €) tn) N.G. Check the following.

CHECK POWER SUPPLY.

e 10A fuse 1) Turn ignition switch ‘OFF’. e Harness continuity 2) Disconnect fuel pump relay. between fuse and fuel 3) Turn ignition switch “‘ON”’. pump relay 4) Check voltage between terminals @ @, ® and ground. If N.G., repair harness or Voltage: Battery voltage connectors. 0, O.K. Vv MEF709A N.G. Check the following.

CHECK GROUND CIRCUIT.

e Harness connectors 1) Turn ignition switch ‘““OFF’’. (uy), 2) Disconnect fuel pump harness con- 0 DISCONNECT zs4)

fe] [oS

e Harness continuity nector. e\lo Ala between fuel pump and 3) Check harness continuity between terminal @ and body ground, termi- body ground nal © and terminal @). e@ Harness continuity [2] between fuel pump and Continuity should exist. fuel pump relay O.K. If N.G., repair harness or connectors.

1D] Vv - DISCONNECT €) N.G. Check the following.

CHECK OUTPUT SIGNAL CIRCUIT.

e Harness connectors(@9), 1) Disconnect E.C.U. harness connec- [=] ry bic a tor. f} d e e Harness continuity 2) Check harness continuity between E.C.U. terminal@0D and terminal @. between E.C.U. and fuel (i pump relay Continuity should exist. If N.G., repair harness or O.K. connectors. O.K. MEF710A

=

DISCONNECT >” DISCONNECT

AE) AE)

mane (C__cvunrr_

fol connector |

104

y, MEF711A

EF & EC-139

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.