WHEEL HUB - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › WHEEL HUB - Nissan 240SX 1991-1992 Workshop Manual
WHEEL HUB
REAR AXLE — Wheel Hub and Axle Housing
Disassembly
CAUTION: Wheel bearing with flange usually does not require mainte- nance. If any of the following symptoms are noted, replace wheel bearing assembly (including flange, and inner and outer seals). @ Growling noise is emitted from wheel bearing during operation. @ Wheel bearing drags or turns roughly when hub is turned with your hand after bearing lock nut is tightened to SRA108A specified torque. @ After wheel bearing is removed from hub.
WHEEL HUB
Remove wheel bearing (with flange) and wheel hub as one unit from axle housing before disassembling.
WHEEL BEARING
@ Using a press and drift as shown in figure at left, press wheel bearing out. @ Discard old wheel bearing assembly. Replace with a new wheel assembly.
SRA109A @ Remove inner race from hub using a bearing replacer/puller.
CAUTION:
a. Do not reuse old inner race although it is of the same ' brand as the bearing assembly. $T30031000
b. Do not replace grease seals as single parts. (J22912-01)
SRA110A
RA-11
Parts & tools for this job For Nissan 240SX
- PARTWheel bearingSearch: Nissan 240SX wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Nissan 240SX cv boot kit
As an Amazon Associate we earn from qualifying purchases.