CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
CYLINDER HEAD
CYLINDER HEAD
CAUTION: When installing sliding parts such as rocker arms, camshaft e@ and oil seal, be sure to apply new engine oil on their sliding surfaces. When tightening cylinder head bolts, intake camshaft e sprocket bolts and camshaft bracket bolts, apply new engine oil to thread portions and seat surfaces of bolts. Attach tags to valve lifters so as not to mix them up. e
Removal This removal is the same procedure as those for timing e chain. Refer to ‘‘Removal” in ‘TIMING CHAIN”.
Disassembly Remove intake manifold, collector assembly and exhaust
1. manifold. Refer to ‘‘Outer Component Parts’”’. Remove valve components with Tool.
2. Remove valve oil seal with a suitable tool.
3.
SEM692D
EM-24
Parts & tools for this job For Nissan 240SX
- PARTEngine gasket setSearch: Nissan 240SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.