Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Oil pump - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Oil pump - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXOil pump - Nissan 240SX 1991-1992 Workshop Manual

Oil pump

ASSEMBLY Adjustment (Cont'd)

2. Adjust total end play. Oil pump assembly

Oil pump

Total end play “T:’”: gasket

0.25 - 0.55 mm (0.0098 - 0.0217 in)

Bearing Needle Clutch SAT9O75A bearing pack race

a. With needle bearing installed, place J34291-1 (bridge), (J3429 1-5) J34291-2 (legs) and the J34291-5 (gauging cylinder) onto oil Lock 4 (J34291-2) pump. The long ends of legs should be placed firmly on machined surface of oil pump assembly and gauging cylin- der should rest on top of the needle bearing. Lock gauging cylinder in place with set screw. (J34291-1) Needle bearing

SAT976A Install J84291-23 (gauging plunger) into gauging cylinder.

With original bearing race installed inside reverse clutch drum, place shim selecting gauge with its legs on machined surface of transmission case (no gasket) and allow gauging plunger to rest on bearing race. Lock gauging plunger in place with set screw.

Remove Tool and use feeler gauge to measure gap between gauging cylinder and gauging plunger. This measurement should give exact total end play. Total end play ‘T,’”’:

0.25 - 0.55 mm (0.0098 - 0.0217 in) If end play is out of specification, decrease or increase thickness of oil pump cover bearing race as necessary. | Available oil pump cover bearing race: Refer to S.D.S. SAT979A

AT-173

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.