Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

METER AND GAUGES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › METER AND GAUGES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXMETER AND GAUGES - Nissan 240SX 1991-1992 Workshop Manual

METER AND GAUGES

METER AND GAUGES

Fuel Tank Gauge Unit Check

@ For removal, refer to FE section. Check the resistance between terminals @ and ©. O E|G

Ohmmeter (+) | (-)Float position Resistance Fuel value mm (in) Q 2 (US gal, Imp gal)
(+) | (-)mm (in) Q 2 (US gal, Imp gal)
Approx. 57.6 * - 5, Ty) Full | 99 (3.62) | *3°°3 | (15-1/4, 12-5/8)
GPEx Approx. 32.9 2 | V2 | 54 (6.08) | 277-343 | (gaya, 7-1/4)
Approx. 6.6 * 78.3 - 84.8 3 | Empty | 996 (8.90) | 72 (1-3/4, 1-1/2)

SEL407L

Thermal Transmitter Check

Ohmmeter a Check the resistance between the terminals of thermal transmitter and body ground. lf] O —--

Water temperatureResistance
60°C (140°F)Approx. 70 - 902
100°C (212°F)Approx. 21 - 242

SEL698F

Oil Pressure Switch Check

Ohmmeter Check the continuity between the terminals of oil pressure switch and body ground. e@¢ : &

Oil pressure kPa (kg/cm?, psi)oo, Continuit onenany
Engine startOoo parenNO
. Engine stopLess than 10 - 20 (0.1 -0.2, 14-28)YES

i

SEL748K |

Speed Sensor Signal Check

Speed sensor

1. Remove speed sensor from transmission. Location: Refer to ‘Location of Electrical Units’’.

2. Turn speedometer pinion quickly and measure voltage across @) and ®). Speed sensor pinion Voltmeter : Gfe)

[V]] Approx. 0.5V

[Alternating current (A.C.)] SEL408L EL-59

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.