Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 5 (Cont'd) & poaeppd ~

DIAGNOSTIC PROCEDURE 5-3

HS. €) Ge

Turn ignition switch and lighting

; switch OFF. Push control unit connector v O | Disconnect push control unit il 114] L/OR harness connector. | ‘

NG. Check 10A fuse at fuse block.

CHECK POWER SUPPLY

RHA431A A GO +

FOR PUSH CONTROL UNIT.

(Refer to “POWER SUPPLY Bi} Do approx. 12 volts exist be- ROUTING” in EL section and tween push control unit harness

A/C ELECTRICAL CIRCUIT.)

terminal No. and body ty” ‘a UPB ground? € (Er) Push control unit O.K. connector B} i Note : ron | | |

CHECK BODY GROUND

17 ~ -

CIRCUIT FOR PUSH CON-

24 OTMN

TROL UNIT.

_———> RHASG4C Does continuity exist between push control unit harness ter- minal No. @2 and body ground? O.K. v Replace control amp. built-in push control unit.

DIAGNOSTIC PROCEDURE 5-4

switch OFF,

"| Turn ignition switch and lighting €) Vv Pus h control unit

Disconnect push control unit

connector harness connector. 5 = | | [17 | P + Note ——— \ J

CHECK BODY GROUND

123 4 s RHA564C|

| CIRCUIT FOR PUSH CON-

TROL UNIT.

Does continuity exist between push control unit harness ter- minal No. @?) and body ground? | O.K. y Replace control amp. built-in push control unit. Note: If the result is N.G. after checking circuit continuity, repair harness or connector. HA-91

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.