Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Basic Inspection (Cont'd)

WMONITOR

YWNOFAIL [_]

N.G.

OFF

CHECK SWITCH INPUT SIGNAL.

START SIGNAL

Repair or replace the Vv

ON on Select the following switches in malfunctioning switch or OFF

IDLE POSITION

AIR COND SIG

“DATA MONITOR” mode, its circuit.

NEUTRAL SW

ON a) Start signal, b) Idle position, c) Air conditioner signal, d) Neutral (Parking) switch, and | RECORD check the switches’ ON-OFF op- SEF723K eration. OR Cap Remove E.C.U. from front floor (a

panel and check the above

A/C switches’ ON-OFF operation us- ing voltmeter at each E.C.U. ter- minal. Switch Condition Voltage (V) Start IGN — IGN 0 — Battery signal ON START voltage Engine warmed up sufficiently “SEF 1501 Idle Idle position Battery voltage —-0V position — Depress the accelera- tor pedal. AIC |. A/C A/C OFF ON

7.0 - 10.0 signal (Engine > 0.5 - 0.7 running) Shift lever is Neutral “oN” or “pr (Parking) position >

08.0 - 10.0 switch Except ‘’N’’ and “’P”’

O.K.

WSELF-DIAG RESULTS

| 8] v Yes

,| Go to the relevant inspec-

READ SELF-DIAGNOSTIC RESULTS.

TIME

FAILURE DETECTED

"| tion procedure.

0 cy

ENGINE TEMP SENSOR

1. Perform ““SELF-DIAG RESULTS” mode.

2. Read out self-diagnostic re- sults.

3. Is a failure detected? OR | ERASE || | . Set ‘‘Self-diagnostic results SEF1511 mode’”’ in Mode II. (Refer to page EF & EC-42.)

2. Count the number of RED L.E.D. or check engine light flashes and read out the codes.

3. Are the codes being output? No Vv Check engine light

INSPECTION END

RED L.E.D.

SEF621K

EF & EC-57

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.