Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

When CONSULT is not used: ® - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › When CONSULT is not used: ® - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXWhen CONSULT is not used: ® - Nissan 240SX 1991-1992 Workshop Manual

When CONSULT is not used: ®

SUPER HICAS SYSTEM — On-vehicle Service Inspection of HICAS System Operation (Cont’d)

7. Operate engine at speeds greater than 2,000 rpm, and turn steering wheel 180° in one direction from the neutral Neutral position position. Measure extension value of one power cylinder rod and retraction value of the other. Then, turn steering C) wheel 180° in the other direction from the neutral position, Stroke and measure extension value of one cylinder rod and retraction value of the other. Determine strokes of respec- tive power cylinders by adding (measured) extension and retraction values. Measure rod strokes in as short a period of time as possible. Specifications: SST378B When turned to the right 3 mm (0.12 in) When turned to the left 3 mm (0.12 in) Total stroke 6 mm (0.24 in)

When CONSULT is not used: ®

4 sec. Have a helper sit in the driver’s compartment and raise vehicle. wheel (Use a 2-pole lift or a center pole lift so that the four wheels R.H. are free to rotate.) (Rear \ L.H. Set HICAS system in self-diagnosis mode. Turn ignition switch ““OFF’’. angle) pressure Set shift lever to ‘‘P’’ or ‘‘N” position (A/T model), or Oil steer ‘“‘Neutral’”’ position (M/T model). Time i Turn ignition switch ‘‘ON”’. SST445B Immediately start engine. Turn steering wheel from left to right (at least 20° from the neutral position ) 5 times or more, then depress foot brake pedal at least 5 times all within 10 seconds after ignition switch has been turned ‘“‘ON”’. Set steering wheel to a point approximately 10° from the neutral position and check to ensure that rear wheels turn to the left and right alternately.

ST-29

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.